Air pressure brakes of commerical vehicles

Large commercial vehicles like trucks and buses use pneumatic brakes. These so called EBS work with compressed air and must be regularly checked for their full functionality. The test bench uses pressure sensors and a measuring system. With its universal measuring device, which is suitable for a wide range of physical sizes, bmcm has developed a solution for this application which offers the highest accuracy even in dynamic processes.

The measuring system records the signals of the pressure sensors that are connected to the measuring points and can measure up to 16 pressures at the same time, depending on the model. The time-synchronous detection of the brake pressures is essential for the correct representation of the response curve. The appropriate output voltage for the sensor supply can be configured, thus providing broad support for most sensors.

With the software NextView®4 – also by BMC Messsysteme GmbH – the display and evaluation of the signals or the pressure curve of each wheel is immediately possible without time-consuming programming.

Hence leaks and inadequate pressure distribution are immediately visible. The measurement process and the analysis take place automatically, saving time and eliminating reading errors.

Due to the modular design of the measuring system, this solution can be used either as an independent pressure measuring system or integrated into a test bench.